1. Locate the existing Turn-signal flasher. 
   See your vehicle manual for its location.  If a manual is not available,
   the turn-signal flasher can be located by trial and error (see a and b below).
   (a) Turn ON Ignition switch and operate the turn-signal lever in either direction.
   (b) Feel for a relay type unit (sqare or round) that is pulsing in synchronism with
        the flashing of the turn sigal lamps.
2. Turn OFF the Ignition Switch and remove the flasher from its socket.
3. Locate the SOUND & LED MODULE for a convenient audible and visual presentation
    Use the Velcro supplied to secure the module to its location.
4. Install the Turn-Alarm flasher into the turn signal flasher socket.   
5. Route the cable attached to the Turn-Alarm flasher to the module and plug the
    connector into the module.
6. Secure the cable to wiring or other parts using the cable ties provided..
7. Turn ON the Ignition Switch and operate the turn-signal lever in either direction.
8. You should hear a "BEEP" from the Turn-Alarm and see the LED flash.
9. Return the Turn-Signal Lever Switch to "OFF" and the "beep" should stop.

BACK