TURN-ALARM INSTALLATION INSTRUCTIONS - UNIVERSAL TYPE

1. Open the battery compartment and install a 9V Alkiline battery by attaching the battery to the battery clips. Close the battery compartment. 2. Locate the Control Unit on the dash in a convenient location so that the LED and sound transducer can be heard and seen. Use the VELCRO strips that are provided. 3. Mount the Motion Sensor to the Turn-Signal Lever using the Velcro Pads. (Place one of the pads on the the Turn Signal Lever and the other on the SENSOR). Secure the SENSOR in the proper position for use and then secure the wire to the Turn-Signal Lever with the ty-wrap to provide some strain relief. See the picture below for the proper postion to mount the Motion Sensor. NOTE: THE PROPER MOUNTING POSITION FOR THE MOTION SENSOR IS CRITICAL FOR THE UNIT TO SENSE MOTION WHEN THE TURN-SIGNAL LEVER IS MOVED FROM AND RETURNED TO THE NEUTRAL POSITION. THE MOTION SENSOR MUST BE MOUNTED SO THAT THE ARROW ON THE SENSOR IS POSITIONED TO SENSE VERTICAL MOTION. 4. Position the POWER SWITCH to the "ON" position. 5. Positon the Turn-Signal Lever to either the LEFT or RIGHT Turn position. 6. You should hear the sound transucer "beep" and observe the LED flash. 7. Return the Turn-Signal Lever Switch to the NEUTRAL position. The sound and LED flash should stop. 8. Repeat Step 5 & 6 & 7 for the other position of the Turn Signal lever. 9. Tapping the Turn Signal Lever again when the unit is operating should terminate the operation.

BACK

DAECO
10664 CORNERSTONE CIR.
STOCKTON, CA 95209
(209) 952-0923
11/14/12
Turnalarm@yahoo.com