TURNALARM COMPATIBILITY - REPLACEMENT TYPE

1. Locate the turn signal flasher in your vehicle. It is usually mounted under the dash, in a fuse panel, on the inside firewall, or under the console (motorhome). a) MANY VEHICLES HAVE 2 FLASHERS; ONE FOR TURN SIGNALS AND ONE FOR HAZARD. IF YOUR VEHICLE HAS ONLY ONE FLASHER, THEN THE FLASHER IS USED IN BOTH THE TURN-SIGNAL AND HAZARD MODE. IF THIS IS THE CASE, WE RECCOMMEND THAT YOU USE OUR MODEL 262 TURNALARM WHICH CAN HANDLE UP TO 12 LAMPS. b) To locate the TURN-SIGNAL flasher, activate the directional signal and listen or feel for a faint click coming from the flasher. 2. Remove the existing turn signal flasher and replace it with the TURNALARM. 3. To be compatible with the Models 552, 552LL, Model 262 TURNALARMS, the flasher removed must be a 2 terminal (X,L) or 3 terminal (+,L,-) flasher with 1/4 inch male spade terminals. Either type can be a round or square unit. See table below for cost.

4. DAECO DOES MANUFACTURE OTHER LOUD TURN-SIGNAL FLASHERS TO FIT VEHICLES WITH OTHER TYPE FLASHERS AS FOLLOWS:

NOT SURE ABOUT WHICH MODEL TURNALARM IS RIGHT FOR YOUR VEHICLE?
CLICK HERE to E-Mail DAECO FOR PROPER SELECTION OR CALL DAECO AT (209) 952-0923

a) Late model GMC and CHEVROLET VEHICLES & PICKUP TRUCKS (4 terminal flasher with 1/8. in spade lugs). Use TURNALARM MODEL 6051. See table below for cost. b) Late model FORD and DODGE VEHICLES & PICKUP TRUCKS (5 terminal flasher with 1/4 inch male spade lugs). Use TURNALARM Model 607. See table below for cost. c) SATURN vehicles, Models SL and SC (3 terminal flasher with 1/8 in. spade lugs). Use TURNALARM MODEL 6136. See table below for cost. d) TOYOTA vehicles (3 terminal flashers with 1/4 in. spade lugs). Use TURNALARM MODEL 35. See table below for cost. d1) Late model TOYOTA vehicles (8 in-line terminal flashers with 1/8 in. spade lugs). Use TURNALARM MODEL TOYOTA SP8. See table below for cost. d2) Late model TOYOTA vehicles (12 in-line terminal flashers with 1/8 in. spade lugs). Use TURNALARM MODEL TOYOTA SP12. See table below for cost. d3) Late model TOYOTA vehicles (18 in-line terminal flashers with 1/8 in. spade lugs). Use TURNALARM MODEL TOYOTA SP18. See table below for cost. e) HONDA AND OTHER JAPANESE vehicles (3 terminal flashers with 1/4 in. spade lugs). Use TURNALARM MODEL 34. See table below for cost. e1) Late model HONDA vehicles (6 in-line terminal flashers with 1/8 in. spade lugs). Use TURNALARM MODEL HONDA SP. See table below for cost. f) Street Rods and Hot Rods (with converted 12 V. wiring using 2 terminal thermal flashers with 1/4 in. spade lugs) Use TURNALARM MODEL 552, or MODEL 552LL. See table below for cost. g) Street Rods & Hot Rods (with converted 12 V. wiring using 3 terminal(X,P,L) thermal flashers with 1/4 in. spade lugs) Use TURNALARM MODEL 550. See table below for cost. g1) Vehicles using 3 terminal(X,P,L) electronic flashers with 1/4 in. spade lugs) Use TURNALARM MODEL 263. See table below for cost. h) Street Rods & Hot Rods (Using 6 Volt - 3 terminal thermal flashers with 1/4 in. spade lugs) Use TURNALARM MODEL 535.See table below for cost. h1) Street Rods & Hot Rods (Using 12 Volt - 2 terminal thermal flashers with 1/4 in. spade lugs) which operate "LED TURN SIGNAL LAMPS" Use TURNALARM MODEL 262LED. See table below for cost. i) 1997-2000 JEEP WRANGLER, 1995-1999 DODGE & PLYMOUTH NEON using a 4 terminal 1/4 in. spade terminal, use TURNALARM MODEL 26. See table below for cost. j) MODEL MC-2 (2 TERMINAL REPLACEMENT TYPE TURN-ALARM WITH REMOTE SOUND & LED) - See table below for cost. k) MODEL MC-3 (3 TERMINAL REPLACEMENT TYPE TURN-ALARM WITH REMOTE SOUND & LED) - See table below for cost. j) CHRYLER vehicles WITH 5 terminal flashers. Use TURNALARM MODEL 470. See table below for cost. k) CHRYLER vehicles WITH 9 terminal flashers. Use TURNALARM MODEL 519. See table below for cost. 5. If the existing turn-signal flasher does not meet the requirements in 3 or 4 above, note the number on the flasher or obtain the P/N of the flasher from your vehicle dealer and e-mail or forward that information to DAECO. Also indicate the make, model, and year of the vehicle. 6. If the existing 2 or 3 terminal turn-signal flasher is located outside of the driverís compartment, the TURNALARM can be relocated to inside the compartment (so that it can be heard) by the use of a 2 ft. extension cable (for flashers with 1/4 in. male spade lugs only). See table below for cost.

ALL COSTS INCLUDE SHIPPING AND HANDLING

DAECO MODEL NO. COST CA RES. COST
EXT. CABLE$6.95$7.73
552$22.95$24.47
552LL$24.95$26.63
262$34.95$37.43
262LED$38.95$41.75
263$36.95$39.59
607$34.95$37.43
6051$32.95$35.27
6136$32.95$35.27
34$32.95$35.27
35$32.95$35.27
550$24.95$26.63
535$26.95$29.73
26$32.95$35.27
MC-2$26.95$28.79
MC-3$26.95$28.79
HONDA SP$49.95$57.09
TOYOTA SP8$58.95$63.24
TOYOTA SP12$80.95$86.87
TOYOTA SP18$90.95$97.67
470 $79.95$85.79
519$79.95$85.79


BACK

DAECO
10664 CORNERSTONE CIR.
STOCKTON, CA 95209
(209) 952-0923
10/31/13
website: turnalarm.com
email: turnalarm@sbcglobal.net